3
Package contents:
Remote Control
Mattress Retainer Bar
Power Adapter
Base Legs
Y-cable (optional for Tandem control)
IMPORTANT UNPACKING
INSTRUCTIONS
To avoid damage to the power
base, always open the carton
while the power base is laying in
the FLAT position on the oor.
OPEN FLAT
STEP 7A
Manufactured by Reverie
®
For Warranty and Service:
1-800-973-8374
customerservice@reverie.com
Please have your receipt ready and
available.
Thank you and enjoy your power base.
www.reverie.com
Register Online. For easy registration
of your warranty visit
https://reverie.com/register-your-
warranty
Please prepare a digital copy of your
proof of purchase (invoice or sales
receipt) when registering online. You
may be required to provide the Serial
Number for registration, you can nd it
on the Law Tags attached to the base.
If you have a tool free retainer bar,
Insert it into the two mount holes
located at the foot end of the power
base.
STEP 1
STEP 3
STEP 2
STEP 4
STEP 8
STEP 5
STEP 6
Assemble the power base legs.
Screw them in a clockwise direction
into the threaded holes in the frame.
Remove the securing fasteners on
the accessory components, and set
them aside from the undercarriage
of the base.
Remove the zip ties securing the
excess cord from the motors of the
power base.
Carefully ip the power base over with
2 people, to the topside-up position.
Plug the power cord into a grounded
electrical outlet.
NOTE: An electrical surge
protection unit is recommended
(not included)
WARNING: POWER CORDS
MUST NOT INTERFERE
WITH ANY POWER BASE
MECHANISMS.
ATTENTION!
Improper handling
DO NOT
lean the power
base against the
installed legs to
ip it over.
WARNING: PACKAGING
MATERIAL MAY SMOTHER
SMALL CHILDREN AND PETS
If you are installing a headboard,
proceed to follow the Headboard
Bracket Assembly Guide on our
website. If not, place your mattress
on top of the power base. Power
base assembly is now complete.
Carefully pull the folded power
base unit out of the shipping carton.
Remove and discard the plastic bag.
Unfold the base keeping the unit top
side down. For safety reasons, this
should be performed by 2 people.
Frame Assembly Instructions
STEP 7B
If you have a retainer bar that
requires hardware, use the retainer
bolts and retainer bar plates to
fasten the Retainer Bar to the
power base. DO NOT use a power
screwdriver to tighten the bolts.
To Next Page
Loading...