TRAINING _
1. Read the operators manual careful/y. Be
thoroughly familiar with the operation of the
equipment.
2.
Know where the controls are and how to oper-
ate them.
3.
Wear safety goggles, ear protection and mask
in dusty operations.
4. Never allow unsupervised children to operate
equipment. Never allow adults to operate the
equipment without proper instruction.
5.
Keep work area clear of other persons.
6. Maintain a clean uncluttered work area.
OPERATION SAFETY _
1. Never make any adjustments while the
machine is running.
2 .
Disconnect electrical power supply before do-
ing any adjustments on the machine.
3. Remove all working tools and equipment be-
fore starting machine.
4. Wear proper clothing. Avoid loose fitted cloth-
ing, long sleeves, long hair, gloves, neck ties,
jewelry, watches, rings, ete.
5 .
Do not operate an electrical device in a damp
or wet area to avoid electrical shock.
6. Maintain all safety guards.
7 .
Do not operate machine while under the in-
fluence of medication, alcohol or drugs.
8. Never leave machine running unattended.
9. Don't overload machine. Follow operators in-
struction for safe operation.
1 O.
Keep equipment in proper working order. Fol-
low recommended maintenance procedures
in the operators manual.
SETUP •••••••••••••••••
NOTE: Damage and/or missing parts are to be
reported to the transportation carrier.
Manufacturer is not responsible for ship-
ping damage.
This saw is shipped complete in, two cartons:
Carton
1
Carton
2
1.
Saw
1.
Legs
2. Operators manual 2. Glides (leg bottom)
3. Extra blades 3. Attaching hardware
1. Remove saw from shipping carton.
2. Check for damage.
3. Remove legs from carton.
4. Install one leg on each corner of the base us-
ing 1/4" carriage bolts and nuts. (The top of the
leg should be inside of the base.)
5.
Install one
3/8/1
nut on each of the four glides.
6. Insert the glides up through the hole in the bot-
tom of the leg. (See Fig. 1)
7. Install the second 3/8" nut on the glide to
secure.
8. With all of the legs installed, position the saw
upright and adjust the nuts on the glides so
that each glide supports the saw.
FIG. 1 1/4" NUT
1/4" CARRIAGE ~
BOLT
3/8" NUT
BASE
LEG
3
GLIDE
NOTE:
Optional adjustable 6" leg extension is
available. Part #6LE (See Accessories)
To Next Page
Loading...