Need help?Do you have a question about the Hawk 220 and is the answer not in the manual?
Performance| throat depth | 20" |
|---|---|
| max cutting depth | 2" |
| stroke | 1 1/8" |
| strokes per minute | 700-1300 |
Motor and Drive| motor | 1/8 H.P. TEFC |
|---|---|
| drive | Belt |
Weight and Dimensions| length | 33" |
|---|---|
| width | 16" |
| height | 45 1/2" |
| weight | 98 Ibs. |
Begin cuts at points or corners for smoother blending; cut on outside curves.
Feed wood slowly, let the blade work, maintain downward pressure, avoid sideways pressure.
Angle work 2-4 degrees to compensate for blade set to achieve straight cuts.
Cut 360° turns; turn piece for points, follow curves slowly, use smaller blades for tight radii.
Saw with the table tilted to create angled sides on projects.
To Next Page