Hawk X Pro Series - Normal Operation; Arming the Alarm System; Normal Arming Mode; Automatic Arming

NORMAL OPERATION
Arm Alarm Disarm alarm
Mute alarm
Remote start
ARMING THE ALARM SYSTEM
NORMAL ARMING MODE
To arm the alarm system, turn the ignition switch OFF, press the button, indicators will
flash once; with single audible bleep LED starts to flash the alarm system will enter into
the arming status after 5 seconds. If motorcycle is slightly moved, the alarm will chirp and
the indicator will flash lights 5 times, if it’s moved hard then full reaction will occur and
sound for 30 seconds. Engine will be completely immobilised and can not be driven away.
(if immobiliser installed).
AUTOMATIC ARMING
In any case, the alarm system will arm itself automatically 60 seconds after the ignition
has been switched OFF.
To disable the function of automatic arming, press button and button simultaneously,
indicator light will flash 4 times, auto-arming function is disabled. To enable this function,
press button and button again at the same time, siren sound 4 times, indicator light
flash 4 times, auto-arming function is enabled.
DISARMING THE ALARM SYSTEM
T
CHANGE SIREN TONE (default single tone)
Press + buttons simultaneously indicator lights flash 2 times, siren sound 2 times
for 6 tone. For single tone follow above procedure, indicator lights flash 2 times.
o disarm the alarm system, press the
button, indicators flash twice with two audible
bleeps. If the system was triggered during arming, indicator LED light will flash quickly
after disarming. The LED will also flash quickly when the system is alarming.
1
21
CONNECTING THE ALARM WITH SPECIFIC T HARNESS
(OPTIONAL EXTRAS)