What to do if Hawksmoor Trimmer cutting time per battery charge is too low?
If the cutting time per battery charge is too low, the issue may be due to several factors. First, there might be too much friction due to a lack of lubricant; in this case, apply lubricant spray. Second, the blade may need cleaning, so clean the blade. Finally, the battery may not be fully charged; if this is the case, recharge the battery.
Why Hawksmoor TOOLSTATION ASYPHT1510 Trimmer pole hedge trimmer does not operate?
The pole hedge trimmer may not operate because the battery is discharged (recharge the battery), the battery is not fully connected (ensure the battery pack release button is fully locked), or the machine head is not assembled well with the pole (check to see if the machine head and the pole are assembled in place).
What to do if Hawksmoor TOOLSTATION ASYPHT1510 blades are running slow?
If the blades are running slow, it could be because the battery is discharged (recharge the battery) or the battery is stored outside of battery temperature (allow battery to warm naturally to room temperature, within the battery operating temperature 5–45ºC).
What to do if Hawksmoor TOOLSTATION ASYPHT1510 Trimmer cutting blade is hot?
If the cutting blade is hot, it may be because the cutting blade is dull (have blade sharpened), the cutting blade is damaged (have blade inspected/overhauled), or there is too much friction due to a lack of lubricant (apply lubricant spray).
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug in any way.
Stay alert, watch what you are doing and use common sense when operating a power tool.
Do not force the power tool. Use the correct power tool for your application.
Have your power tool serviced by a qualified repair person.
Use the tool only with specifically designated battery packs.
To reduce the risk of electrocution, never use the extended-reach hedge trimmer near power lines.
Fully charge battery pack before the first use.
Charge only battery pack of the same model provided by manufacturer.
This product requires assembly. Carefully remove the product and any accessories from the box.
Hold the telescopic extension rear handle and the hedge trimmer head level and still.
To extend the shaft, open the lever latch (8) on the telescopic shaft and extend by pulling.
This long reach hedge trimmer provides 10 cutting positions for different cutting applications.
Insert the battery pack to the machine by sliding the battery pack into the slot of the battery port.
Remove the blade protection sheath from the blade before operation.
Press the battery capacity level button to check the charging level of the battery pack.
Slide the battery pack into the charger base to make connections.
Describes the meaning of LED indicators during battery charging.
To Next Page
General
