To Next PageTo Next PageWhy is the water temperature difference too high in my Hayward Air Conditioner?
If the temperature difference between the inlet and outlet water is too high in your Hayward Air Conditioner, it could be due to insufficient water flow volume or a water pressure difference that is either too low or too high. Verify the water flow and check for any system obstructions.
What to do if my Hayward Air Conditioner has a flow detector defect?
If your Hayward Air Conditioner indicates a flow detector defect, it could be due to insufficient water flow or a short-circuit/defective detector. To address this, verify the water flow, filtration pump, and the flow detector, checking for any potential problems.
What to do if my Hayward Air Conditioner has a communication problem?
If your Hayward Air Conditioner is experiencing a communication problem, the issue might stem from the LED controller or the PCB connection. You can resolve this by checking the connection of the NET and NET 1 cables.
What to do if my Hayward Air Conditioner shows low pressure protection?
If your Hayward Air Conditioner is showing a low pressure protection error, it may be because the refrigeration circuit pressure is too weak, the airflow is insufficient, or the coil is obstructed. Here’s how to address it: 1. Verify the low pressure switch and the refrigeration circuit pressure to check for leaks. 2. Clean the coil surface. 3. Check the fan rotation speed. 4. Ensure there's free airflow to the coil.
What should I do if my Hayward Air Conditioner's compressor won't start?
If the compressor on your Hayward Air Conditioner isn't starting, the issue might be a missing phase or an incorrect phase order. To resolve this, check that all three phases are present and, if necessary, modify the phase order at the heat pump’s electrical connection terminal block.
What to do if my Hayward Air Conditioner shows high pressure protection?
If your Hayward Air Conditioner displays a high pressure protection error, it could be due to several reasons: the refrigeration circuit pressure being too high, low water flow, an obstructed coil, or weak airflow. You should: * Verify the high pressure switch. * Check the refrigeration circuit pressure. * Ensure proper water or air flow. * Confirm the flow switch is working. * Verify the water inlet/outlet valve openings. * Check the by-pass setting.
What to do if the E03 alarm code appears on my Hayward EnergyLine pro?
If the E03 alarm code appears on your Hayward Heat Pump regulator, it means the pool filtration pump might not be running. Make sure that the pool filtration pump is running.
General