To Next PageTo Next Page
Need help?Do you have a question about the Hayward H350IDL2 and is the answer not in the manual?
General| Model | H350IDL2 |
|---|---|
| Heating Capacity | 350, 000 BTU |
| Heat Exchanger Material | Cupro Nickel |
| Energy Efficiency Rating | 84% |
| Water Flow Rate | 40-120 GPM |
| Ignition Type | Electronic |
| Heater Type | Natural Gas |
Crucial safety information regarding fire, explosion, and gas leaks.
Essential emergency procedure for gas leaks.
Overview of the product and manual.
Key details on product warranty coverage.
Guides for choosing the appropriate heater model for pools and spas.
Specific instructions and tables for determining heater size.
Initial checks and site considerations before installation.
Guidelines for compliance with codes and proper heater placement.
Instructions for configuring water connections.
Specifies required clearances for different installation types.
Details necessary air flow for safe and efficient operation.
Guidelines for installing the heater in enclosed areas.
Procedures and tables for negative pressure venting systems.
Instructions for installing the indoor adapter kit.
Tables for determining appropriate vent diameters and heights.
Guidance for positive pressure venting systems.
Steps for installing the special gas vent adapter.
How to attach the vent to the adapter.
Tables for sizing natural gas and propane gas lines.
Guidelines for connecting gas supply and safety precautions.
Information on water connections and suitable water types.
Explains components and methods for plumbing connections.
Instructions for installing a manual bypass valve if needed.
Visual guides for connecting the heater in various pool setups.
Guidelines for heaters installed above the water level.
Recommendations for integrating chemical feeders.
Detailed instructions for electrical hookups.
How to connect 2-wire thermostats and 3-wire switches.
Steps for setting up bypass operation with remote thermostats.
Initial steps before gas and pressure testing.
Procedures for leak testing and verifying gas pressure.
How to adjust the gas pressure regulator if necessary.
Specific installation notes for below-surface mounting and pump types.
Basic operation, water balance, and chemical management.
How to operate the heater and use chemical feeders safely.
Step-by-step procedures for starting and stopping the appliance.
Important safety advice regarding water temperature and medication use.
How to use the temperature controls and adjust settings.
Steps for handling ignition failures and flame loss.
Recommended maintenance checks and seasonal shutdown.
Procedures for draining and preparing the heater for the season.
Overview of maintenance tasks and accessing controls.
Instructions for inspecting and cleaning the external heat exchanger.
Procedures for removing the heat exchanger and combustion chamber.
Procedures for inspecting, cleaning, and removing burners.
Steps for replacing the gas valve and ignitor.
Information on burner orifices and gas type conversion.
Procedures for servicing the control module and display.
Maintenance for the fuse board and vent pressure switch.
Instructions for replacing high limit switches.
How to service blower vacuum and water pressure switches.
Procedure for replacing the thermistor.
Procedures for servicing internal valves.
Instructions for replacing the transformer.
Steps for replacing the combustion blower.
Initial checks, reset options, and understanding error codes.
Detailed explanation of soft and hard lockout 'LO' errors.
Troubleshooting supply wiring and internal wiring problems.
Comprehensive chart for diagnosing heater faults.
A comprehensive list of all replaceable parts.
Visual guide to identify and locate parts.
Details on what the warranty covers and its limitations.
Procedures for submitting a warranty claim.
Specific warranty for FireTile™ components.
Detailed explanations of error codes displayed by the heater.
Guidance on how to resolve issues indicated by error codes.
