Hayward HCC 2000 - Technical Specifications - System Details; Safety Systems and Sensor Requirements; Power Input, Outputs, and Optional Equipment

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
21
Safety Systems: pH & ORP Audible & Visual Alarms
Controller Unit DIagnostic Self Test
Required Flow Sensor
Optional Remote Alarm
pH & ORP Sensors: Casing Material Molded ABS
Junction Type Teflon Reference
Wet End 1/2” NPT
Connector Shielded BNC
Sensor Output Signal
Requirements: 0 - 14 pH 0 - 1000 mV ORP
Power Input: 120/240 Volt AC, 10 AMP 50/60 Hz
Outputs: pH Feed 4 AMP / 120 VAC
4 AMP / 240 VAC
1 AMP / Dry Contact
ORP Feed 4 AMP / 120 VAC
4 AMP / 240 VAC
1 AMP / Dry Contact
Remote Alarm 1 AMP / Dry Contact
Optional Equipment: Chemical Feed Pumps
CO
2
pH Systems