starting the circulation system. Failure to do so could result in severe personal injury and/ or
damage.
WARNING – Separation Hazard. Failure to follow safety and operation instructions could
result in violent separation of pump components. Strainer cover must be properly secured to pump
housing. Before servicing pool and spa circulation system, all system and pump controls must be in
off position and filter manual air relief must be in open position. Do not operate pool and spa
circulation system if a system component is not assembled properly, damaged, or missing. Do not
operate pool and spa circulation system unless manway cover is in seated position in filter body. All
suction and discharge valves MUST be OPEN when starting the circulation system. Failure to do so
could result in severe personal injury and/ or property damage.
WARNING – Never operate or test the circulation system at more than 50 PSI maximum.
WARNING – Failure to install according to defined instructions may result in severe personal injury
or death.
WARNING – ELECTROCUTION HAZARD. High voltage electricity is present in the pool and
spa equipment. High voltage electricity can cause shock and electrocution. Shock and electrocution
can result in severe personal injury or death.
All electrical wiring MUST be in conformance with applicable local codes, regulations and the
National Electrical Code (NEC).
Before performing any service or maintenance on electrical equipment turn off all electrical
power.
Contact a licensed electrician or building inspector for information on local electrical codes for
bonding requirements.
Verify water discharge from the filter manual air relief valve is directed away from electrical
devices.
Do not locate pump controls over or near filter.
To Next Page
Loading...
Need help?
General
