Need help?Do you have a question about the Hayward Pool Vac XL™ and is the answer not in the manual?
General| Type | Suction Pool Cleaner |
|---|---|
| Pool Type | In-ground |
| Power Source | Pool Filtration System |
| Cleaning Coverage | Floor and Walls |
| Warranty | 1-year limited warranty |
| Weight | 15 lbs |
| Hose Length | 40 feet |
Section to record purchase date and serial number for convenience.
Important note regarding spring start-up use and debris load.
Check and remove pool debris, verify water level, and balance chemistry.
Clean or backwash the filter, and clean hair and lint prior to installation.
Connect connector hoses and leader hose, ensuring tight connections to prevent air leaks.
Ensure correct hose length for pool size and attach Flow Gauge to leader hose.
Turn on filter system, eliminate air, and connect hose to skimmer or Vac Lock.
Check flow reading on gauge and adjust using valves or Regulator Valve.
Notes on using Regulator Valve and Skimmer Vacuum Plate for high vacuum.
Remove Flow Gauge and mark 3-way valve for future adjustments.
Set rear flap adjuster, submerge cleaner to remove air, then connect hose.
Ensure return line flow does not affect cleaner steering or pool coverage.
Ensure cleaner moves freely without excessive time on obstructions.
Adjust rear flap for optimal wall climbing and suction performance.
Notes on cleaning behavior in fiberglass vs. vinyl liner pools.
Instructions on proper hose storage to avoid memory and voiding warranty.
Details on connecting to different skimmer types with or without regulator.
Adjusting vari-flow/diverter valve in skimmer for proper suction.
Ensure cleaner is operating efficiently; too much or too little vacuum is bad.
Periodically check that the cleaner hose is securely attached to its suction source.
Disconnect hose before backwashing to avoid restricting water flow.
Always carry the cleaner by its molded-in handle, not by the hose.
Remove cleaner from water when swimming or for chemical treatments.
Periodically check wear indicators on shoes and wings for replacement.
Step-by-step guide for removing and replacing cleaner shoes.
Instructions for removing and replacing cleaner wings, matching L/R sides.
Detailed steps for replacing front and rear flaps, noting spring differences.
Recommendation to bring unit to dealer for skirt/mid section replacement.
Recommendation to bring unit to dealer for skirt/mid section replacement.
Instructions for opening the bottom for cleaning and maintenance.
Steps to clean the turbine/vacuum chamber after opening the bottom.
Identifies causes and solutions for slow or no forward movement.
Troubleshooting steps for failure to climb walls in gunite/concrete pools.
Solutions for cleaner climbing too high and sucking air.
Causes and solutions for the cleaner head not settling on the pool bottom.
Troubleshooting steps for cleaner getting stuck on pool features.
Disclaimers regarding pool surface materials and user responsibility.
Details needed when calling Hayward's Technical Service Department.
Instructions for completing and returning the warranty registration card.
Details on warranty coverage for all cleaner components for one year.
Details on warranty coverage for Pool Vac XL/Navigator Pro components for two years.
Terms and conditions that apply to the limited warranty.
Clauses related to force majeure and assignment of the warranty agreement.
Procedure for reporting defects and finding authorized service centers.
Details on dispute resolution and limitations of Hayward's liability.
To Next Page