To Next PageTo Next Page
Need help?Do you have a question about the Hayward Navigator and is the answer not in the manual?
General| Type | Automatic Pool Cleaner |
|---|---|
| Pool Type | In-Ground |
| Warranty | 1 Year Limited |
| Pool Surface Compatibility | Fiberglass, Vinyl |
| Power Source | Pool's filtration system |
| Compatibility | Most In-Ground Pool Filtration Systems |
Clean filter and basket, check water balance and remove debris before installation.
Connect Navigator hose sections together, ensuring tight seals to prevent air leaks.
Ensure hose reaches pool's farthest part, attach leaf trap and vacuum gauge.
Immerse Navigator to expel air, connect grey end to cleaner, then connect hose to skimmer.
Start filtration, check vacuum gauge for optimal water flow (approx. 25mm per hose length).
Monitor cleaner movement, adjust rear flap knob for steps, obstacles, or stuck situations.
Adjust flap for wall climbing and water surface entry; reduce suction if climbing too high.
Ensure hose connection, disconnect for back-washing, avoid coiling hose, manage chlorine levels.
Utilize removable bottom for turbine/suction chamber access for servicing and cleaning.
Pool liner damage can occur from aging, sunlight, chemicals, or pool environment.
Address issues like insufficient flow, blockages, worn pads or wings, or weak suction.
Resolve problems related to worn parts, short hoses, or steering system failures.
Troubleshoot insufficient flow, blockages, worn parts, short hoses, or flap tension.
Correct issues with excessive flow, wrong flap tension, or steering system faults.
Details limited warranty for defects, exclusions, and claim procedures.
