USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 4
INSTALLATION INSTRUCTIONS:
1. Place vacuum cleaner head on vacuum hose and prepare for vacuuming as usual. With pump and
filter system operating, fill vacuum hose with water.
2. Keeping water in hose, place hose end over SKIM-VAC hose connection.
3. Insert SKIM-VAC into skimmer and firmly place over basket. Hold SKIM-VAC in place until all air is
evacuated from vacuum hose. Once the air is removed, the pump suction will hold the SKIM-VAC
firmly in place.
4. To remove SKIM-VAC, merely grasp the hose connection (near the plate) and give a sideward
twist or briefly lift vacuum head from pool. This will "break" the suction and allow easy removal.
NOTE: Take care not to damage or scuff-up SKIM-VAC's specially designed sealing surface. For best
results, store the SKIM-VAC in a safe place when not in use.
NOTE: SP1106 and SP1107 SKIM-VACS, fit 7” baskets. SP11063 fits 8” baskets.
Mode
Description Skimme
Gasket
SP1094D 1 ¼” x 1 ½” Combo hose elbow SP1094, SP1095 No
SP11041 1 ¼” x 1 ½” Combo hose elbow SP1090, SP1091, SP1092 front access No
SP11051 1 ½” Hose straight adapter SP1090, SP1091, SP1096, SP1097, SP1098, Top cover Yes
SP11052 1 ¼” Hose elbow SP1090, SP1091, SP1092 front access Yes
SP11054 1 ¼” x 1 ½” Combo hose elbow SP1090, SP1091, SP1092 front access Yes
SP1106 1 ½” Hose straight adapter SP1082, SP1084, SP1085, SP1075 Yes
SP11063 1 ½” Hose straight adapter SP1070 No
SP1107 1 ½” Hose straight adapter SP1082, SP1084, SP1085, SP1070, SP1075 No
SP11071 1 ¼” x 1 ½” Combo hose elbow SP1089 No
To Previous Page
Loading...
