HBC micron 7 - Tandem Operation; Tandem Operation T1; Tandem Operation T2

Tandem Operation
Tandem Operation T1
The radio system consists of 1 transmitter and 2 receivers for 2
machines. The transmitter can control the machines individually or in
parallel
The machines are selected at the transmitter via a rotary switch:
A only machine A
A+B machine A + machine B
B only machine B
Tandem Operation T2
The radio system consists of 2 transmitters and 2 receivers for 2 machines. Both transmitters are master
transmitters and can control the machines individually or in parallel.
During normal operation transmitter 1 controls machine A and transmitter 2 controls machine B. In order
to be able to switch to machine B or A+B at transmitter 1, for example, the key must be removed from
transmitter 2 and inserted in transmitter 1.
The machines are selected at the transmitter via a rotary switch:
A only machine A
A+B machine A + machine B
B only machine B
Operating Example: Control of machine A + B via transmitter 1.
1. Switch transmitter 1 and 2 off and remove the key from transmitter 2.
2. Insert the key from transmitter 2 in transmitter 1.
Machine selection via transmitter 1 is activated.
3. Turn the rotary switch of transmitter 1 to A+B.
4. Switch transmitter 1 on and actuate the start button.
The radio system now operates in tandem mode.
Warning:
For safety reasons, it is imperatively required that only one key is available for each transmitter.
The spare key must be stored at a superior, authoritative position and only be handed out in
clarified cases.