HBK T12HP - Table of Contents

To Next Page

To Previous Page

T12HP

TABLE OF CONTENTS

1 Safety instructions 5................................................

2 Markings used 10....................................................

2.1 Symbols attached to the transducer and/or stator 10......................

2.2 The markings used in this document 11.................................

3 Scope of supply 12...................................................

4 Operation 13........................................................

5 Application 14.......................................................

6 Signal flow 15.......................................................

7 Structure and mode of operation 17....................................

8 Mechanical installation 18............................................

8.1 Important precautions during installation 18..............................

8.2 Conditions on site 19.................................................

8.3 Mounting position 19.................................................

8.4 Installing the slotted disc (rotational speed measuring system only) 19.......

8.5 Installing the rotor 20.................................................

8.6 Fitting the protection against contact (option) 23..........................

8.7 Installing the stator 28................................................

8.7.1 Preparing with the mounting kit (incl. among the items supplied) 30.........

8.7.2 Aligning the stator 32.................................................

8.7.3 Stator installation over the protection against contact (option) 34...........

8.8 Optical measuring system for speed/angle of rotation (option) 35...........

8.8.1 Axial alignment 35...................................................

8.8.2 Radial alignment 36..................................................

9 LED status display 38................................................

9.1 Measuring mode operation 38.........................................

9.2 Rotor clearance setting mode operation 38..............................

9.3 Rotational speed measuring system setting mode operation 39.............

10 Electrical connection 40..............................................

10.1 General information 40...............................................

10.1.1 Using the EMI filter/toroidal strip-wound core, for applications in the USA and

Europe 40..........................................................

10.2 Shielding design 42..................................................