5
T12HP
SAFETY INSTRUCTIONS
1 SAFETY INSTRUCTIONS
Adherence to FCC Rules and warning notice
Important
Every variation or modification that is not explicitly agreed with the person responsible for
adherence to the Rules, could invalidate the user’s operating license for the device. If addi
tional components or accessories are defined elsewhere for use during installation of the
product, these additional components or accessories must be used, to ensure adherence
to FCC Rules.
This device complies with Part 15 of the FCC regulations. Compliance with the following
two conditions is a requirement of operation: (1) This device may not cause harmful inter
ference; and (2) this device must tolerate any interference signal received, including inter
ference that could cause undesirable operation.
The FCC identification number or the unique identification number, as appropriate in each
case, must be attached to the device where it is clearly visible.
Model Measurement
range
FCC ID IC
T12S2 100 Nm, 200 Nm 2ADAT-T12S2 12438A-T12S2
T12S3 500 Nm, 1 kNm 2ADAT-T12S3 12438A-T12S3
T12S4 2 kNm, 3 kNm 2ADAT-T12S4 12438A-T12S4
T12S5 5 kNm 2ADAT-T12S5 12438A-T12S5
T12S6 10 kNm 2ADAT-T12S6 12438A-T12S6
The FCC ID number in relation to the measurement range.
To Next Page
Loading...