91
T12HP
SPECIFICATIONS
10532kNVmNominal (rated) torque M
nom
Weight, approx.
Rotor kg 4.9 8.3 14.6
Stator kg 2.4 2.5 2.6
16)
Option 9, code U
17)
Option 9, code N
18)
Each type of irregular stress (bending moment, lateral or axial force, exceeding nominal (rated) torque)
can only be permitted up to its specified limit, provided none of the others can occur at the same time.
If this condition is not met, the limit values must be reduced. If 30% of the bending limit moment and
lateral limit force occur at the same time, only 40% of the axial limit force is permissible and the
nominal (rated) torque must not be exceeded. The effects of 10% of the permissible bending moments,
axial and lateral forces on the measurement result are ≤±0.02% (Code S,U); ±0.01% (Code W) of the
nominal (rated) torque.
19)
Limit loads / Option 4, Code F (high-speed version): Limit loads (bending moment, lateral or axial force
and oscillation width (peak-to-peak)) are reduced by 20%.
20)
The nominal (rated) torque must not be exceeded.
21)
The influence of radial run-out deviations, eccentricity, defects of form, notches, marks, local residual
magnetism, structural inhomogeneity or material anomalies needs to be taken into account and
isolated from the actual undulation.
To Next Page
