NOTE: The speed of lowering is controlled by the release valve. The more the valve is
opened the more rapidly the lift descends. Ensure the decent is slow and controlled.
When the lift is fully lowered, unstrap the motorcycle, open the vice jaws and remove the
cycle from the lift.
MAINTENANCE
When not in use, the lift must be stowed in the lowest position in a dry location to
minimize ram and piston corrosion.
Keep the lift clean and wipe off any oil or grease. Lubricate all moving parts.
Periodically check the ram and piston for signs of corrosion. Clean exposed areas with a
clean oiled cloth.
Before each use check all parts. If any part of the lift is damaged or suspect, remove the lift
from service and take necessary action to repair.
Check the hydraulic oil level. If not adequate, remove the filler plug(P33) on the pump and
add hydraulic oil as necessary.
DO NOT use brake fluid or any other improper fluid. Only a good quality hydraulic jack oil
can be used.
When lift efficiency drops, purge away air from the hydraulic system as described
PUMP
To Next Page
Loading...