To Next PageTo Next PageWhat to do if Health O Meter 752KL do not turn on?
If your Health O Meter scales do not turn on, there are a few potential causes. First, the batteries may be dead, so try replacing them. Second, the electrical outlet could be faulty; try using a different outlet. Finally, the power supply might be bad; in this case, replace the adapter.
What to do if Health O Meter Scales display shows “LO Bat” message?
If the display on your Health O Meter scales shows a “LO Bat” message, it means the batteries are dead. Replace the batteries according to the provided instructions.
How to fix Err 5 on Health O Meter 752KL Scales?
Err 5 on Health O Meter scales means calibration is disabled. Toggle the calibration switch to enable it.
Why Health O Meter 752KL Scales show questionable weight or do not zero?
If your Health O Meter scales are showing a questionable weight or not zeroing, consider these possibilities: First, an external object might be interfering with the scale; remove any such objects. Second, the display may not have shown ‘000.00’ before weighing; in this case, have the patient get off the scale, zero it, and begin the weighing process again. Third, the scale might not be on a level floor; place it on a level surface and restart the weighing process. Finally, the scale may be out of calibration; check the weight with a known weight value.
What to do if Health O Meter Scales display shows “OVER”?
If the display on your Health O Meter scales shows “OVER”, it indicates that the load on the scale exceeds its capacity of 600lbs. Remove the excess weight to continue using the scale within its limits.
What does Err 6 mean on Health O Meter Scales?
Err 6 on Health O Meter scales indicates a high saturation state (high A/D). This means the load cell is not connected correctly. Check the connection, cables, and mechanical connection. If the problem persists, replace the set of load cells.
What does Err 7 mean on Health O Meter 752KL?
Err 7 on Health O Meter scales indicates a low saturation state (low A/D). See Err 6 for troubleshooting steps.
What does Err 3 mean on Health O Meter 752KL Scales?
Err 3 on Health O Meter scales means unstable weight. Check the load cells' mechanical surroundings to ensure nothing is touching them and that the cables are well connected.
What does Err 2 mean on Health O Meter 752KL?
Err 2 on Health O Meter scales indicates that the weight loaded is too low, and calibration cannot be performed. While in the calibration procedure, add more weight in load mode.
What does Err 1 mean on Health O Meter 752KL Scales?
Err 1 on Health O Meter scales indicates a mathematical mistake, specifically division by zero. This happens when trying to calibrate without any calibration weight.
General| Type | Digital |
|---|---|
| Weight Capacity | 400 lbs |
| Graduation | 0.2 lbs |
| Display | LCD |
| Auto-On/Off | Yes |
| Low Battery Indicator | Yes |
| Power Source | Batteries |
