HearthStone Quality Home Heating Products Inc Tucson Model #8700
› WARNING: DO NOT OPERATE THE APPLIANCE WITH THE FRONT GLASS
REMOVED, CRACKED OR BROKEN. REPLACEMENT OF GLASS SHOULD BE DONE BY
A LICENSED OR QUALIFIED SERVICE PERSON. ONLY OPEN FRONT FOR ROUTINE
SERVICE. DO NOT SLAM OR STRIKE GLASS.
CERAMIC FIBER LOG SAFETY
INFORMATION
If the decorative ceramic log material
supplied with the Tucson is damaged or
missing, it must be replaced with the same,
approved replacement parts supplied by the
manufacturer. These components affect the
combustion quality and safety of the heater.
Do not replace fiber ceramic logs with
unapproved ceramic logs or any other
material.
Always wear gloves and safety goggles
while handling the log set and ember
strip.
!ELECTRICAL HAZARD!
When the optional blower kit is installed, the
Tucson must be electrically grounded in
accordance with local codes, or in the
absence of local codes, with the National
Electrical Code, ANSI.NFPA 70 in the U.S.
or CSA C22.1 Canadian Electrical Code in
Canada. The Tucson fan accessory is
equipped with two blower fans. The three-
prong grounded plug must be plugged
directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding prong from the plug or otherwise
attempt to circumvent the grounding
protection provided with the unit.
DO NOT LIGHT PILOT OR MAIN
BURNERS BY HAND
The standing pilot light equipped on this gas
heater is lit by using a piezoelectric spark
generator as described elsewhere in this
manual. Never attempt to light the pilot or
main burners by hand with a match or
lighter. If, after repeated attempts, the pilot
light fails to light, discontinue operation,
turn off the gas at the gas control valve, and
immediately contact qualified service
personnel for assistance.
Certified for use by:
Board of State Examiners of Plumbers and Gasfitters
100 Cambridge Street, Room 1511
Boston, Massachusetts
02202
To Next Page
Loading...
Need help?
General
