Heat Controller RADS-151H - Important Safety Instructions; For Your Safety; Electrical Information; Operation of Cur Rent Device

Heat Controller, Inc. Room Air Conditioner with R-410A Owner’s Manual
4
IMPORTANTSAFETY INSTRUCTIONS
Besuretheelectricalserviceisadequateforthemodelyouhave
chosen. Thisinformationcanbefoundontheserialplate,which
islocatedonthesideofthecabinetandbehindthegrille.
Besuretheairconditionerisproperlygrounded. Tominimize
shockandfirehazards,propergroundingisimportant. Thepower
cordisequippedwithathree-pronggroundingplugforprotection
againstshockhazards.
Yourairconditionermustbeusedinaproperlygroundedwall
receptacle.Ifthewallreceptacleyouintendtouseisnotadequately
groundedorprotectedbyatimedelayfuseorcircuitbreaker,
haveaqualifiedelectricianinstalltheproperreceptacle.
Ensurethereceptacleisaccessibleaftertheunitinstallation.
Donotrunairconditionerwithoutsideprotectivecoverinplace.
Thiscouldresultinmechanicaldamagewithintheairconditioner.
Donotuseanextensioncordoranadapterplug.
WARNING
Foryoursafety
Donotstoreorusegasolineorotherflammablevaporsandliquidsin
thevicinityofthisoranyotherappliance.
Avoidfirehazardorelectricshock.Donotuseanextensioncordoran
adaptorplug.Donotremoveanyprongfromthepowercord.
WARNING
ElectricalInformation
NOTE Forsomemodels,thepower
supplycordwiththisairconditioner
containsacurrentdetectiondevice
designedtoreducetheriskoffire.
PleaserefertothesectionOperation
ofCurrentDevicefordetails.
Intheeventthatthepowersupply
cordisdamaged,itcannotbe
repaired-itmustbereplacedwitha
cordfromtheProductManufacturer.
,
,
Donot,underany
circumstances,cut,
remove,orbypass
thegroundingprong.
Powersupplycord
with3-pronggroundingplug
andcurrentdetectiondevice
Operationof Cur rentDevice
(Applicabletotheunitadoptscurrentdetectiondeviceonly)
Thepowersupplycordcontainsacurrentdevicethatsensesdamagetothepowercord. Totestyourpower
supplycorddothefollowing:
1.Pluginthe AirConditioner.
2. Thepowersupplycordwillhave TWObuttonsontheplughead.Pressthe TEST button,youwillnoticea
clickastheRESET buttonpopsout.
3.PresstheRESET button,againyouwillnoticeaclickasthebuttonengages.
4. Thepowersupplycordisnowsupplyingelectricitytotheunit.(Onsomeproductsthisitalsoindicatedby
alightontheplughead.)
Donotusethisdevicetoturntheunitonoroff.
AlwaysmakesuretheRESET buttonispushedinforcorrectoperation.
Thepowersupplymustbereplacedifitfailsresetwheneitherthe TEST buttonispushed,oritcannotbe
reset. A newonecanbeobtainedfromtheproductmanufacturer.
Ifpowersupplycordisdamaged,itcannotberepaired.ItMUST bereplacedbyone
NOTES:
obtainedfromthe
productmanufacturer.
4
Please refer to the section “Operation
of Current Device” for details.