Heat-N-Glo 6000 XLS User Manual

WARNING
IF THE INFORMATION IN
THESE INSTRUCTIONS IS
NOT FOLLOWED EXACTLY, A
FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY,
OR LOSS OF LIFE.
- Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
- What to do if you smell gas
 Do not try to light any appliance.
 Do not touch any electrical switch.
 Do not use any phone in your building.
 Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
 If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
Heat-N-Glo Fireplace
Models:
6000 GDVFL
6000 XLS
U.S. Patents 4,793,322; 4,875,464; 5,000,162 and Patents Pending
Canadian Patent 1,297,746
Installers Guide
WARNING: IMPROPER
INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR
MAINTENANCE CAN CAUSE
INJURY OR PROPERTY DAMAGE.
REFER TO THIS MANUAL. FOR
ASSISTANCE OR ADDITIONAL
INFORMATION CONSULT A
QUALIFIED INSTALLER, SERVICE
AGENGY, OR THE GAS SUPPLIER.
A.G.A. Design Certified/CGA Certified and
Underwriters Laboratories Listed. See
Approvals Tabel on Page 1.
446-982-A 8/97
READ THIS MANUAL BEFORE INSTALLING
OR OPERATING THIS APPLIANCE. THIS
INSTALLERS GUIDE MUST BE LEFT WITH
APPLIANCE FOR FUTURE REFERENCE.
1.This appliance may be installed in an
aftermarket, permanently located,
manufactured (mobile) home, where
not prohibited by local codes.
2. This appliance is only for use with the
type of gas indicated on the rating
plate. This appliance is not convertible
for use with other gases, unless a
certified kit is used.
Please contact your Heat-N-Glo Fireplace
dealer for any questions or concerns. For the
number of your nearest Heat-N-Glo dealer,
please call 612-890-8367.
Printed in U.S.A.
Copyright 1997,
Heat-N-Glo Fireplace Products, Inc.
6665 West Highway 13, Savage, MN 55378

Heat-N-Glo 6000 XLS Specifications

General

Type	Gas Fireplace
Vent Type	Direct Vent
Dimensions	Varies by model
Ignition Type	Electronic Ignition
Log Set Material	Ceramic Fiber
Fuel Type	Natural Gas or Propane
Heating Capacity	Up to 2, 000 sq. ft
Control Type	Remote Control
Burner Material	Steel

Summary

Section 1: Approvals and Codes

Approval Listings and Codes

Details the certification standards and laboratories for Heat-N-Glo fireplace models, including specific model certifications.

Installation Codes

Section 3: Installing the Fireplace

Step 1 Locating the Fireplace

Step 2 Framing the Fireplace

Step 3 Installing the Vent System

Covers vent system approvals, components, and detailed instructions for attaching and securing vent pipes and firestops.

Step 5 The Gas Control Systems

Explains the two types of gas control systems used: Standing Pilot Ignition and Direct Spark Ignition (DSI).

Step 6 The Gas Supply Line

Details the installation of the gas supply line, including shut-off valves, connections, and leak checking procedures.

Step 7 Gas Pressure Requirements

Step 8 Wiring the Fireplace

Provides wiring diagrams and instructions for Standing Pilot Ignition and Direct Spark Ignition (DSI) systems.

Step 12 Lighting the Fireplace

Section 4: Maintenance and Servicing

Fireplace Maintenance

Provides a table outlining required maintenance tasks, frequency, and who should perform them, emphasizing safety.