Heat-N-Glo SL-32 User Manual

WARNING
IF THE INFORMATION IN
THESE INSTRUCTIONS IS
NOT FOLLOWED EXACTLY, A
FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY,
OR DEATH.
- Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
- What to do if you smell gas
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
Heat-N-Glo Fireplace
Models:
SL-36
SL-36GDV
SL-32
SL-32GDV
SL-32S
U.S. Patents 4,793,322; 4,875,464; 5,000,162 and Patents Pending
Canadian Patent 1,297,746
Installers Guide
WARNING: IMPROPER
INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR
MAINTENANCE CAN CAUSE
INJURY OR PROPERTY DAMAGE.
REFER TO THIS MANUAL. FOR
ASSISTANCE OR ADDITIONAL
INFORMATION CONSULT A
QUALIFIED INSTALLER, SERVICE
AGENCY, OR THE GAS SUPPLIER.
Underwriters Laboratories Listed.
454-980-A 4/98
READ THIS MANUAL BEFORE INSTALLING
OR OPERATING THIS APPLIANCE. THIS
INSTALLERS GUIDE MUST BE LEFT WITH
APPLIANCE FOR FUTURE REFERENCE.
1.This appliance may be installed in an
aftermarket, permanently located,
manufactured (mobile) home, where
not prohibited by local codes.
2. This appliance is only for use with the
type of gas indicated on the rating
plate. This appliance is not convertible
for use with other gases, unless a
certified kit is used.
Please contact your Heat-N-Glo Fireplace
dealer for any questions or concerns. For the
number of your nearest Heat-N-Glo dealer,
please call 612-890-8367.
Printed in U.S.A.
Copyright 1998
Heat-N-Glo Fireplace Products, Inc.
6665 West Highway 13, Savage, MN 55378

Heat-N-Glo SL-32 Specifications

General

Brand	Heat-N-Glo
Model	SL-32
Category	Indoor Fireplace
Language	English

Summary

Heat-N-Glo Fireplace Installers Guide

Product Models Overview

Lists the available Heat-N-Glo fireplace models covered in the guide.

Critical Safety and Warning Information

Crucial safety information and warnings before installation and operation.

Detailed Safety Precautions

Expands on safety precautions and potential hazards.

Section 1: Approvals and Codes

Appliance Certification and Listings

Details the certifications and standards the appliance meets.

Installation Codes and Standards

Outlines applicable local and national installation codes.

High Altitude Installation Guidelines

Specific requirements for installations at higher elevations.

Section 2: Getting Started

Introduction to Heat-N-Glo Fireplaces

General overview of the Heat-N-Glo gas fireplace product line.

Pre-Installation Preparation and Checks

Essential steps and considerations before beginning the installation.

Clean Face Kit Installation Requirements

Specific conditions and requirements for installing the Clean Face Kit.

Step 1: Locating and Clearance Requirements

Step 2: Framing the Fireplace Structure

Guides on building the frame around the fireplace unit.

Step 3: Vent System Installation and Termination

Vent System Approvals and Components

Identifies approved vent systems and their parts.

Vent Pipe Assembly and Support

Details on attaching vent pipes, continuing runs, and installing supports.

Firestop and Termination Procedures

Procedures for installing firestops and terminating the vent system.

Step 4: Positioning, Leveling, and Securing

Step 5: Gas Control Systems Overview

Explains the two main types of gas ignition systems.

Step 6: Gas Supply Line and Pressure Requirements

Step 8: Wiring the Fireplace

Electrical connection instructions for the unit.

Step 9: Finishing and Internal Component Assembly

Step 10: Installing Trim, Logs, and Ember Material

Assembly of internal components like logs and embers.

Positioning Fireplace Logs and Embers

Details on placing logs and ember material.

Pre-Lighting and Operation Procedures

Step 11: Before Lighting the Fireplace

Final checks before igniting the fireplace.

Step 12: Lighting the Fireplace

The procedure for starting the fireplace.

Post-Installation Manual Retention

Instruction to leave the installation manual with the appliance.

Section 4: Fireplace Maintenance and Servicing

Routine Fireplace Maintenance Tasks

Specific maintenance activities and their frequency.

Section 5: Replacement Parts and Accessories

Ignition System Parts (Standing Pilot & DSI)

Lists parts for standing pilot and DSI ignition systems.

Common Fireplace Components

Lists common parts, refractory, and log set components.

Optional Fireplace Accessories

Details on available accessories like fan and wall switch kits.