To Next PageTo Next Page
Need help?Do you have a question about the Heat-N-Glo SL-32GDV and is the answer not in the manual?
General| Model | SL-32GDV |
|---|---|
| Type | Direct Vent Gas Fireplace |
| BTU Input (NG) | 32, 000 |
| Firebox Width | 32 inches |
| Venting | Direct Vent |
| Ignition | Electronic Ignition |
| Warranty | Limited Lifetime Warranty |
| Fuel Type | Natural Gas / Propane |
| Control Type | Remote Control |
| BTU Input (LP) | 32, 000 BTU/hr |
Read and understand all instructions before installation or operation.
Do not use if any part has been under water; call service technician immediately.
Unit is not for use with solid fuel.
Installation and repair must be performed by a qualified service person.
Keep clear of combustibles, do not obstruct airflow, locate away from traffic.
Alert children to high temperatures and supervise them near the appliance.
Must use specified vent systems; common vents are prohibited.
Operate only with intact glass door; do not use abrasive cleaners or operate when hot.
Fireplace models tested to certification standards and listed by applicable laboratories.
Fireplace installation must conform to local codes and national standards.
Overview of the direct vent gas fireplaces and their operation principles.
Guidance on preparing for the installation, including checking for damaged parts.
Defines minimum clearances from the fireplace to combustible materials based on location.
Lists approved vent system components for different models, prohibiting others.
Describes common vent system components and the importance of rise-to-run ratios.
Instructions for applying sealant and securing the first vent component to the fireplace.
Guidance on securely fitting and locking subsequent vent components together.
Instructions for installing support brackets for horizontal and vertical vent runs.
Details on installing firestops for horizontal and vertical vent runs through walls and ceilings.
Instructions for attaching and securing vent termination caps for horizontal and round/trapezoidal kits.
Wiring requirements and precautions for the standing pilot ignition system.
Wiring diagram for optional fan accessory installation.
Wiring requirements and precautions for the direct spark ignition system.
Diagram showing clearance requirements for mantels and projections above the fireplace.
Guidelines for installing trim and non-combustible facing materials around the fireplace.
Information regarding hearth extensions for aesthetic purposes.
Instructions for positioning gas logs, especially if sooting occurs.
Details on placing Golden Ember and Glowing Ember material on the burner.
Procedure for replacing ember material annually during a check-up.
Annual cleaning of the burner, controls, and surrounding areas.
Periodically checking flame patterns for proper operation and flame sensor coverage.
Inspecting the external vent cap for debris and ensuring proper venting function.
Instructions for cleaning the glass door using household cleaner, avoiding abrasive cleaners.
Lists replacement parts for fireplaces with standing pilot ignition systems.
Lists replacement parts for fireplaces with Direct Spark Ignition (DSI) systems.
Lists common parts and accessories for both ignition types.
Lists available accessory kits like fan and wall switch kits.
