To Next PageTo Next Page
Need help?Do you have a question about the Heat-N-Glo SL-36GDV and is the answer not in the manual?
General| Type | Gas Fireplace |
|---|---|
| Style | Traditional |
| Width | 36 inches |
| Fuel Type | Natural Gas or Propane |
| Vent Type | Direct Vent |
| Ignition Type | Electronic Ignition |
| Burner Material | Stainless Steel |
| Log Set Material | Ceramic Fiber |
| Glass Type | Ceramic Glass |
General safety guidelines and precautions for operating and installing the fireplace.
Details on the certification standards and laboratories for Heat-N-Glo fireplace models.
Conformance requirements for local building codes and national standards during installation.
Guidelines for adjusting fireplace performance based on elevation.
Overview of Heat-N-Glo direct vent gas fireplaces and their operation.
Crucial steps and considerations before starting the installation process.
Actions that will void the Heat-N-Glo fireplace warranty and disclaim responsibility.
Diagrams and information on fireplace dimensions, locations, and space needs.
Specifies minimum clearances from the fireplace to surrounding combustible materials.
Required clearances between vent pipe sections and combustible materials.
Illustrates framing reference dimensions for different fireplace models.
Approved vent system components and terminations for Heat-N-Glo fireplaces.
Overview of various vent system components and their functions.
Step-by-step guide for attaching the initial vent component to the fireplace starting collars.
Instructions for adding subsequent vent components according to the pre-planned configuration.
Guidance on installing support brackets for both horizontal and vertical vent runs.
Procedures for installing firestops in walls and ceilings to maintain safety.
Procedures for attaching and securing horizontal and round/trapezoidal vent terminations.
Steps for correctly placing, leveling, and securing the fireplace unit.
Details of the standing pilot ignition system components and operation.
Details of the direct spark ignition system components and operation.
Instructions for installing the gas supply line, including connections and leak checks.
Information on the required gas supply line size and connections for the fireplace.
Table detailing minimum inlet, maximum inlet, and manifold pressures for natural gas and propane.
Guidelines for conducting pressure tests on the gas supply system and the fireplace.
Wiring diagram and requirements for the standing pilot ignition system.
Instructions for wiring a remote wall switch to the fireplace.
Wiring diagram and requirements for the direct spark ignition (DSI) system.
Guidelines for minimum vertical and maximum horizontal dimensions of combustibles above the fireplace.
Warnings about not obstructing or modifying air inlet/outlet grilles during finishing.
Guidelines on using sealant material and information about hearth extensions.
Instructions for installing trim, including clearances and sealant requirements.
Step-by-step guide for placing ember material onto the burner.
Procedures for handling the glass assembly, wing nuts, and tension springs.
Essential checks for safety warnings, gas leaks, vent obstructions, and faulty components before lighting.
Steps and considerations for safely lighting the fireplace for the first time.
Instruction to leave the installation manual with the appliance for future reference.
Recommendation for annual servicing by a qualified technician.
Procedure for replacing ember material during annual check-ups.
Instructions for cleaning the burner, controls, and surrounding areas annually.
How to visually check flame patterns for proper operation and sensor coverage.
Regular inspection of the external vent cap for debris and overall vent system function.
Guidelines for cleaning the glass door, including what to use and what to avoid.
List of replacement parts and their numbers for standing pilot ignition systems.
List of replacement parts and their numbers for Direct Spark Ignition (DSI) systems.
Parts common to both ignition systems, including burners, orifices, switches, and glass doors.
Part numbers and descriptions for various log set components.
Optional accessories like fan kits and wall switch kits.
