Motion Sensing Coach
Lights
Tail Assembly
(Lantern & Coach)*
Features
• Light comes on when motion is detected.
• Automatically turns light off.
• Photocell keeps the light off during daylight
hours.
This package includes:
© 2007 HeathCo LLC 595-5530-13
Set ON-TIME switch to
1, 5, or 10 minutes.
ON-TIME
Set the ON-TIME switch
on the bottom of the cover
plate to TEST.
... back on.
1 Second
OFF then...
Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
* Model 4162 includes
additional top assembly parts.
NOTE: When first turned on wait about 1
1
/
2
minutes for the circuitry to calibrate.
Requirements
• The light control requires 120 volts AC.
• If you want to use Manual Mode, the control
must be wired through a switch.
• Some electrical codes require installa-
tion by a qualified electrician.
Mounting screws
and wire connectors
MANUAL MODE
AUTO
* resets to Auto Mode at dawn.
OPERATION
TEST
Mode: On-Time Works: Day Night
Test
5 Seconds x x
Auto
1, 5, or 10 Min x
Manual
To Dawn* x
TEST 1 5 10 MIN
TEST 1 5 10 MIN
ON-TIME
Before installation, record the model number
from back of fixture below. Attach receipt in
case of possible warranty issues.
Carriage Light or Lantern or Coach Light
To Next Page
Need help?
General
