Lighting Controls
This manual includes operating instructions for a variety of remote controlled products.
All products work on the same principle and use the same code setting information.
Please read all instructional information and note any specic information pertaining to
your particular product.
FEATURES
• Products are UL/cUL and/or FCC/IC tested and approved.
• Operational range of up to 100 feet.
Heath
®
/Zenith wireless lighting controls are designed to work together. Simply
determine which transmitter(s) you would like to have control which receiver(s)
and set the code setting to match.
CODE SETTINGS
Note: Most single system installations will not require any
change to the code setting. Transmitter(s) and receiver(s)
must have the same code and group setting to work together.
Switches 1 through 3 set the code. Switch 4 sets the Group
(A or B). See page 2 for switch locations.
Transmitter(s)/
Receiver(s) Code
Group “B”
Example 1 - Code Settings, System 1
(Factory Setting)
Transmitter(s)/
Receiver(s) Code
Group “A”
( – Indicates Position of Switch)
Example 2 - Code Settings, System 2
Note: When operating more than one system independently of each
other, set each system to a different code. There are 8 codes avail-
able by changing the settings of switches 1 through 3.
Transmitter(s)/
Receiver(s) Code
Group “A”
WARNINGS:
• FOR USE ONLY with 120 volt incandescent or halogen bulbs.
• DO NOT USE with uorescent bulbs, appliances, power supplies, low voltage
lighting, or any other electrical devices.
This manual applies to the following
products:
•
Wireless Transmitters (Indoor / Outdoor)
– 180° Motion Sensor
– 240° Motion Sensor
• Receivers
– Wall Switch Receiver
– Floodlight
PAGE REFERENCE GUIDE
Page 3 Page 6 Page 8
Meets the ENERGY STAR
®
guidelines when
DualBrite
®
function is off.
To Next Page
Need help?
General
