Need help?Do you have a question about the Heathkit HW-104 and is the answer not in the manual?
General| Image Rejection | 60 dB |
|---|---|
| IF Frequency | 455 kHz |
| Modes | CW, AM, SSB |
| Power Output | 100 W |
| Receiver Sensitivity | 0.5 μV for 10 dB S+N/N (SSB/CW) |
| Power Supply | 117 V AC |
| Selectivity | 2.1 kHz at -6 dB (SSB) |
Overview of the Heathkit HW-104 Single Sideband Transceiver and its features.
Explanation of how components are packaged for assembly and how to identify them.
General guidelines and tips for successful kit assembly, including soldering techniques.
Detailed parts list and step-by-step instructions for assembling the VFO and Extender circuit boards.
Parts list and step-by-step assembly guide for the Transmitter Audio/REG circuit board.
Component list and assembly instructions for the HFO/Premixer circuit board.
Parts list and step-by-step assembly for the Calibrator circuit board.
Component list and assembly instructions for the Transmitter IF circuit board.
Parts list and assembly steps for VFO Filter and Driver circuit boards.
Detailed component list and assembly instructions for the ALC/Output Filter circuit board.
Parts list and step-by-step assembly for the Carrier Generator/XTAL Filter circuit board.
Parts list and assembly instructions for the Receiver Front End circuit board.
Parts list and step-by-step assembly for the Receiver IF/Audio circuit board.
Component list and assembly instructions for the Power Amplifier circuit board.
List of all parts required for the main chassis assembly.
Instructions for mounting various components and sub-assemblies onto the chassis.
Steps for preparing the front panel, including applying labels and mounting hardware.
Procedure for mounting the front panel and VFO assembly onto the main chassis.
Detailed wiring instructions for components located under the main chassis.
Instructions for installing control knobs and aligning them correctly on the shafts.
To Next Page
