Need help?Do you have a question about the Heathkit HW-100 and is the answer not in the manual?
General| Weight | 25 lbs |
|---|---|
| Image Rejection | 70 dB |
| Modes | CW |
| Tuning | VFO |
| Receiver Sensitivity | 0.5 μV for 10 dB S+N/N |
| Power Requirements | 117 VAC |
| Selectivity | 2.1 kHz at -6 dB, 4.2 kHz at -60 dB |
Specific steps and checks involving the ohmmeter for verifying circuit continuity and resistance.
Instructions for connecting the Heathkit HP-13 series DC power supply to the transceiver.
Detailed steps for connecting the Heathkit HP-23 series power supply, including voltage considerations.
Details on adjusting the driver grid and plate coils as part of the overall alignment process.
Explains how to interpret the readings displayed on the transceiver's meter for various functions.
Step-by-step guide for the initial setup and tuning of the transmitter for operation.
Specific operating procedures and settings for using the transceiver in CW (Continuous Wave) mode.
Technical specifications for the receiver section, including sensitivity and selectivity.
Technical specifications for the transmitter section, including power output and frequency coverage.
A chart showing DC voltage readings for different points in the transmitter section.
To Next Page
