Heathkit IB-5281 - Page 17

Page 15
GeegurarHxKire
(3 Ti: AF transformer (#51-98).
Solder the pins to the foil and
cut off the excess pin lengths.
NOTE: Before you perform the fol-
lowing step, check both sides of the
circuit board inside the dotted line
area to make sure there are no solder
bridges or components inter-
idges or components inte
| changed.
| bye otom shield: Insert the four
(R33: 5 kQ control (#10- 311).
Sulder each control tu the fuil as +
you install it. N se o> HFWy
lugs through the holes in the
circuit board and solder them to
the foil.
(,_ LR9: 100 kO contrat (#1 :
1 <> ee
— [rae
(,4 R14: 500 © control (#10-918). Ae ite
Wa
_+Top shield. Insert the =m | at keaa }
ewer
through the circuit board holes
and solder them to the foil.
Make
sure
the
shield
is
pressed
i
firmly
against
the
circuit
board
and
is
straight.
PICTORIAL 1-6
[
|
|
|
|
|
|.