Heathkit IB-5281 - Final Assembly

GequraryuxiT?
FINAL ASSEMBLY
SELF-RETAINING Refer to Pictorial 5-1 for the following steps.
~] NUT
(+7 Position the cabinet top as shown.
Hf YY / WN ( 4+ Install five self-retaining nuts at V, W, X, Y, and
, py y Ne Z. Insert the slotted end of each nut into the
a, U, YA WY bes cabinet post and press the nut into the hole. Use
wea ( Re r is a screwdriver handle to drive the nut down into
\ NG \ the hole. Set the cabinet top aside temporarily.
AGN .
\ BY W/L za = Refer to Pictorial 5-2 (Illustration Booklet, Page 6) for
\e=
\\
e_
the
following
steps.
rroy tat - ahin we oe ok wo.
[CABINET
TOP
|
TOP
(L}-
Positio
(}-Refer to Detail 5-2A and cut a 2” piece of
PICTORIAL 5-1 double-stick foam tape in half. Then remove the
paper backing from one side of both halves.
(t} Press the double-stick foam tape into battery
compartments BC1i and BC2.
INSET ™, (t-}—In alike manner, prepare the remaining 2” piece
af foam tanean dingtall thea tancin hattary cam
Ul 1UG411L La Pe Gite LiIOLGLE L1G lapo in VaALLOL y Uvuill-
A CUT \ partments BC3 and BC4.
y Ava: 1 BATTERY
NY 4 je CONNECTOR
STORAGE”
JL ee = CLIPS
OF 5-2A
4 UNCHES) 2 a 4 5 6 7
Qa cA oA as 3
~ 14 72 74 eines
1/8,
3/8
|
s/a,
7/8
i
|
]
i
|
12 13 14 15 16 7
Oo 5 1 (CM) 2 3 4 5 6 7 8 9 10 W