Heathkit IB-5281 - Battery Connection

Gegrearixire
oN
C4, me
Ve) |S
WEE Neda
POWER SUPPLY cy)
fo <I
Ee eae
SANE
/ Ae ley IN
yA
ZA
J pe ~~ \\
an — Seer
\
a 4)
SY
tend to use batteries in addition to the
ou int
pply, proceed with the following steps.
Otherwise, Proceed to “Bias Adjustment.”
-~
a Dreitinng 44,4 DIO Datdaga se chris
J Fosiuon We NLU DIlage as SNOWIL.
’ BATTERY CONNECTION
{ } Connect one of the five connector shells coming ; .
from the Power Supply to P1 on the mounting ( ) Connect the two 9-volt batteries, which you
niata ake enra tha wire calare at hath cenannac purchased earlier, to battery connectors BC1
pier AVIGNY OULD LLID WELD UII Oo GL VUE ULI Cu d BC2
tors are the same and are not reversed. an .
( ) Place the LINE/BATT switch to the LINE posi-
tion.
( ) Plug the Power Supply line cord into the ap-
propriate AC receptacle.
( ) Ifyou intend to use batteries at this time, place
the LINE/BATT switch to the BATT position.
Proceed to ‘‘Bias Adjustment” on Page 31.