Heathkit IB-5281 - Page 25

8, -32 NUT
i, AR
Ke
fs 8
#6 LOCKWASHER
METER
CLAMP
RUBBER
SQUARE
Detail 3-2A
Refer to Pictorial 3-2 for the following steps.
ce a te To atal ale
ing from a rubber square. Install the
square on a meter clamp as shown.
(Ly In
he other rubber om anner, install
3
ise] lane) ise]
hey
o> co] =) is} >
a
®
Ps
°
=|
bs -
@
t<>) =}
®
do N
—
c >
wn
(=F Mountthe front panel tothe chassis. Use the red
banana jacks at AB and AGC, and the black
banana jacks at AA and AD. Use the nuts
supplied with the jacks, but do not tighten them
yet. Make sure you do not cross-thread the nuts.
(LY Position the front panel so the level control
Pa aes £51 thaw
shaft and th wie slide switch operate ITecly, tnen
tighten the nuts on the banana jacks.
R26: Mount the 1000 0 control (#11-157) on the
front panel at R26. Use a control lockwasher,
control flat washer, and a control nut. Position
the control lugs as shown.
(Y)