Heatmaxx SRPH98 - Step 13: Front Panel and Handle Installation

$66(0%/<,16758&7,216
14
6WHS
Unscrew the pre-assembled M4 x 10 screw (LL) on the handle (GG), then attach the handle (GG) to the front
panel (#15) with M4 x 10 screw (LL).
Install the front panel (#15) by inserting the two tabs at the bottom into the holes
on the front of the bottom plate (#16). Attach the chain between inside of the door
handle and the front of the burner assembly, then close the panel. The panel
secures with magnet.
127(The chain is used to support the front panel while operating the controls.
+DUGZDUH8VHG
M4 x 10 Screw
(pre-assembly)
1 pc
LL
Handle
1 pcGG
GG
LL