CHAPTER 23
SEASON START-UP MAINTENANCE CHECKLIST
To begin season start-up of your Heatmor
TM
Outdoor Furnace, assuming you followed the
procedures outlined in the “End of Season Maintenance Checklist,” follow the instructions
below:
1. Remove cap from chimney.
2. Build re in rebox and bring your furnace up to temperature. (Refer to the “Lighting
the Heatmor
TM
for the rst time” section of the Heatmor
TM
Operations and Maintenance
Manual.)
3. Once your furnace is up to temperature, you can start all pumps.
CAUTION: It is recommended to start your pumps AFTER you bring your furnace up to
temperature. This helps ensure your system isn’t air locked and ensure your water is
circuating correctly.
4. Your start-up is complete.
66
To Next Page
