Need help?Do you have a question about the Heatrae Sadia MegaFlo and is the answer not in the manual?
General| Type | Unvented Cylinder |
|---|---|
| Material | Stainless Steel |
| Insulation | High-density foam |
| Pressure | Up to 3 bar |
| Heating Element | Immersion Heater |
| Heat Source | Electric |
| Thermostat | Adjustable thermostat |
| Warranty | 25 years (cylinder), 2 years (parts) |
| Capacity | Varies (e.g., 120L, 150L, 200L, 250L, 300L) |
Lists components supplied with the Megaflo unit for installation.
Provides guidance on where to place the Megaflo unit for installation.
Details requirements for the mains water supply pressure and flow rate.
Discusses compatibility and connection of terminal fittings like taps.
Outlines instances where the Megaflo unvented water heater should not be used.
Describes the types and sizes of pipe fittings used for Megaflo connections.
Details recommendations for the cold water supply pipe size and its isolation valve.
Explains the connection and function of the Cold Water Combination Valve.
Describes the use and fitting of the Expansion Core Unit for balanced cold water supply.
Details the installation of the drain tap for servicing and maintenance.
Provides guidance on the recommended pipework from the Megaflo to outlets.
Explains how to connect and use a secondary circulation system.
Describes the installation of insulating components for the T&P relief valve.
Lists critical warnings related to safety valves and installation.
Details requirements for safely conveying discharges from safety devices.
Details the installation, removal, and replacement of immersion heaters.
Provides guidance on electrical wiring for direct units.
Explains the recommended thermostat settings and operation.
Lists important safety precautions for direct units.
Guides on selecting suitable boilers for indirect Megaflo units.
Explains the necessity of the 2-port motorised valve for indirect units.
Details electrical wiring for indirect units and their controls.
Discusses compatible heating system controls for indirect units.
Describes the immersion heater in indirect units and its replacement.
Step-by-step guide to filling and flushing the Megaflo unit.
Instructions on verifying the functionality of safety valves.
Commissioning steps for direct electric Megaflo units.
Commissioning procedures for indirect Megaflo units.
Importance and use of the Benchmark log book for recording installation.
Critical warnings for users regarding safety and faults.
How to control and adjust water temperature for direct and indirect units.
Explains normal flow characteristics and potential cloudiness in water.
Procedure to recharge the air volume in the unit to resolve faults.
Outlines the regular maintenance schedule and requirements.
Steps to check the proper functioning of safety valves.
Instructions on how to clean the strainer in the Cold Water Combination Valve.
Guide on how to drain the Megaflo unit for maintenance.
Detailed steps for descaling immersion heater elements.
Procedure for refilling the system after maintenance.
Key points and warnings regarding servicing and spare parts.
Lists available spare parts with their part numbers.
Introduction to the fault finding chart for identifying and rectifying issues.
Summary of key technical specifications and safety features.
Warning about tampering with the relief valve invalidating the guarantee.
Details the terms and conditions of the product guarantee.
Contact information for customer service and technical support.
Lists suppliers for spare parts.
To Next Page