Need help?Do you have a question about the Heatrae Sadia Multipoint 30 and is the answer not in the manual?
General| Brand | Heatrae Sadia |
|---|---|
| Model | Multipoint 30 |
| Category | Water Heater |
| Language | English |
Details the importance and non-removable nature of the factory-fitted Temperature/Pressure Relief Valve.
Specifies installation must comply with Building Regulation G3 by a competent installer using provided valves.
Instructs immediate power off and contact if water flows from relief valves.
Details requirements for siting the water heater, including wall support and services.
Emphasizes checking the wall's ability to support the unit's full weight.
Prohibits installation in locations where the unit could freeze.
Guides plumbing valves according to Figure 03 and IMPORTANT INSTALLATION POINTS.
Mandates that discharge pipes must terminate in a safe, visible position.
States discharge pipes can drip and must remain open to the atmosphere.
Emphasizes that the appliance must be earthed and suitable for AC supply only.
Provides critical safety notes for users regarding safety valves and discharges.
Lists possible causes and actions for the water not heating.
Addresses continuous discharge from the pressure relief valve, often due to high mains pressure.
Addresses intermittent discharge from the pressure relief valve due to expansion or pressure issues.
Covers discharge of water/steam from the T/P relief valve, usually indicating thermostat faults.
Addresses the issue of no water flow from the unit, checking valves and supply.
Warns against using non-recommended parts, which invalidates the guarantee and is dangerous.
To Next Page