To Next PageTo Next Page
Need help?Do you have a question about the Heatstore HSR25 and is the answer not in the manual?
Lists all components provided with the water heater for installation and use.
Alerts users that installation must be performed by qualified persons only.
Advises on structural support and minimum clearance above the heater lid for access.
Specifies the heater base must be level with or higher than the highest draw-off point.
Details the regulatory requirement for servicing valves on inlet and outlet pipes.
Guides on selecting the best location and securing the heater to the wall.
Recommends using 10mm wall fixings and describes the installation process.
Explains how to fit the float valve and the importance of the correct seating.
Details fitting the overflow assembly, dip tube, and screened breather.
Covers connecting mains water, overflow pipe, heater outlet, and electrical supply.
Specifies supply voltage, fusing, and isolating switch requirements.
Details cable type, cross-sectional area, and connection procedures.
Instructs on connecting the live, neutral, and earth conductors to terminals.
Emphasizes ensuring the supply is off before connecting and not switching on until water flows.
Explains how to adjust the control thermostat for desired water temperature.
Describes the function of the thermal cut-out and its re-setting procedure.
Ensures unit is filled, checks for leaks, and verifies pipework obstructions.
Details opening valves, running hot tap to purge air, and checking water level.
Covers securing the lid, checking for leaks, and turning on the electrical supply.
Outlines steps to isolate power, check water temperature, and drain the unit.
Details loosening cable grips, removing terminal cover, and disconnecting the element.
Covers re-assembly with new gasket, refitting drain nut, terminal cover, and testing.
General| Model | HSR25 |
|---|---|
| Category | Water Heater |
| Frequency | 50 Hz |
| Voltage | 230-240V |
| Thermostat | Yes |
