Heatwave SA1312 - Sauna Assembly and Safety Guidance; Assembly Tips and Requirements

3
ASSEMBLY TIPS & WARNINGS
• Before you begin, read all assembly instructions and safety warnings carefully.
• This sauna requires at least 3 adults to complete assembly.
• Remove all of the contents from the boxes and verify that you have all of the parts shown on the Parts
Identier (Page 5) before you begin assembly. Note: Some parts may be pre-installed or pre-assembled.
• This manual is used for the assembly of several sauna models; therefore, some gures or drawings may
not look exactly like your product.
• Cover the sauna oor during assembly to avoid staining the unnished wood surface.
• Retain this owner’s manual for future reference.
• We recommend consulting a licensed electrician and checking local ordinances before installing ANY
sauna.
• These saunas require a 20 amp receptacle. Note: Electrical modications may be required to
accommodate 20 amp power.
• Refer to the serial plate on the back of the sauna for complete electrical specications.
• These saunas require a dedicated circuit - no other appliances should share the
same outlet with the sauna.
• This sauna should only be placed INDOORS on a dry, level surface.
• There should be a minimum of 5 inches clearance between the sauna and any wall.
• Make sure the main power cord will reach the outlet and remain easy to access.
• The sauna should only be used in a dry location as moisture will damage the wood and electrical
components.
• Keep the sauna away from any potential hazards including water sources, ammable objects, and
combustible materials.
ELECTRICAL REQUIREMENTS:
CHOOSING A LOCATION:
FIRE WARNING: If your sauna is not properly installed by an electrician,
it may cause a house re.