EasyManua.ls Logo

Heatworks MODEL 3 - Installation Guide Overview; Intended Use, Box Contents, and Pre-Installation Steps

Heatworks MODEL 3
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.myheatworks.com | 9
INSTALLATION GUIDE
INTENDED USE
The only approved use of this appliance is to heat potable water for residential purposes and
supplying one or more draw-off points. It is not appropriate to use the MODEL 3 for any other
purpose. If you are unsure about your intended application or installation, please call 888-506-2821
or visit our support page at www.myheatworks.com.
WHAT’S INCLUDED IN THE BOX
Before removing the old tank water heater and beginning installation of the new unit, unbox the
MODEL 3 and check that you have the following:
One (1) MODEL 3 Water Heater with pressure relief valve
One (1) mounting bracket with two (2) pre-installed mounting bracket screws
One (1) MODEL 3 Water Heater Quick Start Guide
Two (2) 3/4” brass nipples
One (1) water pressure regulator preset to 50 psi with o-ring and plumbing union
BEFORE INSTALLATION
In general, the MODEL 3 can be installed in the same location where the old tank water heater was
located or depending local codes, in a more centralized location in your home. However, to ensure safe
performance and keep the warranty in effect, the following precautions must be observed:
ALWAYS read this manual thoroughly and completely prior to installation & use. Failure to follow
instructions could cause property damage, serious personal injury, or death.
A licensed plumber and a licensed electrician are required to install the unit and the installation
must comply with all national, state, and local plumbing and electric codes. Proper installation is the
responsibility of the installer.
Always read this manual before installing the MODEL 3. If you do not follow the Important Safety
Information or the instructions outlined in this manual, your MODEL 3 may not operate properly and it
could cause property damage, serious bodily injury and/or death. Heatworks will not be liable for any
damage because of failure to comply with the installation and operating instructions in this manual.
The installer should leave these instructions with the consumer after installation and demonstration.
By installing this product, you acknowledge the terms of the manufacturers warranty. Once the heater
is installed, do not return product to the place of purchase.
If you have any questions regarding the installation, use or operation of this water heater, please call
our customer support team at 888-506-2821 or visit www.myheatworks.com/pages/support.