29 / 40
PL
SK
DE
EN
CS
HU
• For safety reasons, replace worn or damaged parts. Only use original spare parts and
accessories. Parts not tested and approved by the equipment manufacturer can cause
unforeseeable damage.
• Repair and maintenance work other than described in this section, which are more
complicated, or it needs special tools, let it on our authorized service.
INSTRUCTIONS FOR MACHINE MAINTENANCE
• Frequently check the collection basket for wear or damage.
• For machines with multiple blades, don’t forget that rotation of one blade can start
the rotation of other blades.
• Always be careful when adjusting the machine to avoid jamming fingers between moving
blades and rigid machine parts.
• If you’re repairing a blade, be aware that even though the power supply is switched off,
the blades can still be moving.
• Regularly check the blade for damage.
• Check the grass catcher frequently for wear or deterioration.
CLEANING
CAUTION! A
Never spray the product with water or expose it to water. In any case, do not wash
by water the parts of machine, which are not intended for it.
C Never use aggressive detergents or solvents for cleaning.
1. Carefully clean the machine after each use.
2. Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water. Never use aggressive detergents or solvents for cleaning.
This can cause irreparable damage to the product. The plastic parts can be eaten away by
chemicals.
3. Wipe down the product with a slightly damp cloth or with brush.
4. Clean the cover of the machine, especially the ventilation holes.
5. If any of the parts of the machine is cleaned by water or a damp cloth, etc., it must be
completely dry. Then the metal parts must be grease against the corrosion with suitable
protective oil. Make sure that the water doesn´t leak into the internal parts of the machine.
6. Potential damage of the parts due to corrosion, can not be assessed as a manufacturing or
material defect.
7. After use, clean the outside of the machine, empty the grass-catcher and shake it to remove
grass and other debris.
8. After each use, accurately clean the cutting deck to remove any grass remains or debris.
Regularly remove grass and dirt from the blade. Wipe the surface of the machine and motor
cover with dry cloth.
9. Clean wheels, coat of grass can change the height of cut.
C Always empty the grass-catcher and do not leave containers full of cut grass inside
a room.
To Next Page
Loading...
