hecht 3907 - Training; Safety Instructions

18 / 32
PL
SK
DE
EN
CS
HU
TRAINING
C All operating personnel must be adequately trained in the use, operation and
setting and especially familiar with prohibited activities.
CAUTION! A
This product can be used by children older then 8 years old and persons with reduced
physical, sensory or mental abilities or lack of experience and knowledge only if
are supervised by competent person or have been learned how to use this product,
about safe operation and they understand the potential danger. Children are not
allowed to play with this product. Cleaning and maintenance can not be done by
children without supervision.
SAFETY INSTRUCTIONS
WARNING! B
Failure to follow the warnings and instructions may result in electric shock, fire and/
or serious injury.
The use of other accessories or attachments other than those specified in
the instructions for use, can cause injury.
• Get to know this product. Carefully read the instruction manual. Learn how to use this
product, all restrictions, and what risks could related with its use. Learn the product quickly
stop and turn off the controls.
• Be careful at work, be concentrated on actual work, and use the common sense.
• If the product is not in use, it should be stored in a dry and secure place out of the reach of
children.
• Never pull the plug from the socket by pulling on the cord. Keep the supply cord away from
heat, grease and sharp edges.
• Always disconnect the product from the mains supply before repairing, when changing
accessories, and when the product is not used.
• If the product is used outside, use only extension cord designed for outdoor use and marked
as such.
• Pay attention to what you are doing, be concentrated and think sensibly, do not work with
the product if you are tired, under the influence of alcohol, drugs or medication.
• Faulty switches must be entrusted to an authorised repair service for replacement.
• Do not use this product if the main switch does not allow it to switch on or off.
• This product is designed in accordance with all applicable safety requirements and standards
applicable to it. All repairs should be only made by qualified person and spare parts replaced
by original parts, otherwise the user may be in serious danger.
The measurement results are in accordance with EN 14511.
The test conditions for the data stated on the label comply with the following safety
standard: EN60335-2-40