23 / 32
PL
SK
DE
EN
CS
HU
“SLEEP“ FUNCTION
• In cooling mode, pressing the SLEEP button increases the set temperature by 1 °C in the first hour,
by another 1 ° C in the second hour, and the temperature is then maintained at that temperature.
• In SLEEP mode, ventilation will operate at low speed. Press the SLEEP button again to return
to the preset temperature and ventilation speed.
• The unit will turn off automatically after 12 hours of SLEEP function ON.
Note that the SLEEP function can‘t be selected when the appliance is in AUTO,
VENTILATION or DEHUMIDIFY mode.
If the appliance is in sleep mode, the fan speed changes to LOW.
DEHUMIDIFY MODE (DRYING)
• You can‘t set the temperature in DEHUMIDIFY mode and the ventilation is set to low speed.
• When the appliance is operating in dehumidification mode, the moisture extracted from the air
is collected in the inner tank. When the tank is full, the compressor and fan are automatically
switched off, the "full water tank" warning light comes on and an alarm sounds. (The alarm
can be turned off by pressing any key). The filled tank must be poured out in accordance with
the "DRAINING" paragraph. The unit can also be used with a consistent water outlet with
Outlet hose. (Connection describtion can be found in the "DRAINING" paragraph).
SWING
• When this button is pressed, the slats that move the air direction begin to move (indicated
by an indicator light). Pressing this button again cancels this function.
SELF DIAGNOSTICS
• This appliance has a self-diagnosis function. If something is wrong with the unit, "E1" or
"E2" appears on the display. In this case, contact the service centre.
REMOTE CONTROL
• All of the above functions can be controlled with the remote control included in the package.
(Insert 2 AAA batteries).
C To prolong the compressor’s life, always wait at least 3 minutes before turning it on again.
Note: I
2. If the ambient temperature is lower than the set temperature, the cooling system
will shut down and the ventilation will operate at the set level. If the ambient temperature
rises above the set temperature, cooling will resume.
DRAINAGE
During the cooling process, water is extracted from the air into the appliance’s tank. If the tray is
full, empty the water in one of the following ways:
• If the water tank is full, turn the appliance off and secure it against movement
• Place a container under the drain opening into which you will drain the water from the air conditioner.
• Remove the drain cap and plug from the drain hole and let the water out of the air conditioner.
• Put on the rubber plug and secure it tightly.
• Turn on the unit - the full tank indicator or the inoperative compressor should not be lit.
To use the appliance without emptying the water tank, proceed as follows:
• Remove the drain cap and rubber plug and keep them for future use.
To Next Page
Loading...
