HEDBOX RP-DC50 - Overview; Product Components; Charging Technology

# 2
1.
3.
2.
4.
A
C
7.
5.6.
B
EN
English
Overview
Product Components:
1. Boost Power switch (Boost code)
2. LCD Screen Monitor (Blue Backlight)
3. Charging Slot #1
4. Charging Slot #2
5. AC Power (100V ~ 240V - 50 / 60Hz)
6. DC 12V / 24V Power Input Socket
7. USB-A Power Out 5V ~ 2A /10W
IIntelligent charging systems integrate the control systems within the charger and the
electronics within the battery to allow precise control over the charging process. As a safety
precaution with high-capacity batteries, a pre-charging stage is used. The charging cycle is
initiated with a low current. If there is no corresponding rise in the battery voltage, it indicates
that there is possibly a short circuit in the battery (zero volt activation). Constant current
constant voltage (CC/CV) charging mode effectively charges lithium batteries. When a lithium
battery is nearly empty, we take constant current to charge it. The charger CPU automatically
adjusts the charging current to be lower than the maximum charging current that the battery
can accept. With constant current charging, the battery's voltage rises slowly until it reaches a
maximum voltage at this point, the charger switches the charging method to "constant voltage"
and reduces the charging current. When the battery is fully charged, this state is stopped.
Charging Technology