GENERAL USE – Front Panel
The HD11 DAC is controlled using the supplied RC7 system remote control
On/Off
The power switch is on the rear side of the D/A Converter, next to the mains input. When powered up, the
HD11 will use 15 seconds to calibrate. During this time, the outputs will be muted and the selected input
LED will ash.
NOTE: When powered up the outputs will be muted and the input LED will ash for approximately 15 sec-
onds. This is normal, and is part of the start-up procedure.
Coax 1 Coax 2 Optical USB
HD11 32
bit
To Next Page
Loading...
