HEIL DuraPack 5000 2017 - Page 100

Issued September 2017
Daily Checklist
Copyright 2017, Heil Environmental
Printed in U.S.A.
92
DuraPack
®
5000
CHECKS AND INSPECTIONS
INSPECTION
RESULTS CODE
If equipped, engage the PTO
MOVE the PUMP ON switch UP – the switch’s green light is ON and the PUMP ON light is ON
MOVE the PUMP ON switch DOWN – the switch’s green light is OFF and the PUMP ON light is
OFF
MOVE the PUMP ON switch UP – the switch’s green light is ON and the PUMP ON light is ON
If equipped, The FILTER BYPASSED light is OFF. If not, and the filter was not changed before
starting the unit, report this to your supervisor immediately. DO NOT go on route until the unit is
repaired if the filter was not changed
Operate all optional equipment switches and make sure the option operates correctly, such as a
light
Check the operation of all optional lights. Report any light that is ON and should be OFF or is
OFF and should be ON
Operate the standard outside controls located at the tailgate:
At the same time, PUSH the SLIDE and BLADE levers
The blade should move DOWN
The slide should move IN
At the same time, PULL the SLIDE and BLADE levers
The blade should move UP
The slide should move OUT
Operate each installed optional outside control located at the tailgate:
Reeving Mechanism