1. LOCATION
When selecting a position for your unit you should make sure the floor is flat and firm,
and the room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker,
boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly.
This unit is not designed for use in a garage or outdoor installation. Do not drape the unit
with any covering.
When installing the unit, ensure that 10 cm of free space is left at both sides, 10 cm at
the rear and 30 cm at the top of the unit. This will allow cold air to circulate around the
wine cooler and improve the efficiency of the cooling process.
2. DOOR HANDLE INSTALL ILLUMINATION
To Next Page
Loading...
