www.heinner.com 850W, 50Hz, 220-240V
6
Is there water inside? Is the water
tank located well?
Add water into the water tank, place
correctly the water tank in its position
The preheating process is not
finished
Wait until the process is done
Coffee powder too thick, not
flatten
Make sure the coffee is well grinded and
firmly pressed into the filter
The steam hole was blocked
Use a small wire to poke the steam holes
The appliance does
not flow anymore
hot water, the
steam lamp is ON
and the other two
ore OFF
Ths steam knob is not closed
Coffee powder loading is too much
or less
1 cup 1 spoon with flatten according to the
standard amount of filling, coffee powder
can't be too thick or too thin, too thick
coffee powder can not be complete
extraction, too fine affect the quantity of
coffee
The steam ready indicator is not
illuminated, then begins frothing
milk
Only after the steam ready indicator is
illuminated, the steam can be used to froth
Do not take apart the appliance by yourself, if the failure cannot be found, it is
better to contact the service centre.
To Next Page
Loading...
