PUMP FILTER
A filter system which avoids threads remaining from your laun- dries and tiny materials
from entering into the pump during water discharging operation carried out by your
machine after complet- ing washing so prolonging the lifecycle of your pump is available. It
is recommended that you clean your pump filter once in 2 months. To clean pump filter:
• To open the pump cover, you can use the powder detergent spade or liquid detergent
level plate coming out of your machine.
• Fit the end point of the plastic part to the gap of the pump cover and push it back. This
will open the cover.
• Before opening the filter cover, settle a vessel in front of the filter cover to prevent the
water remained in the machine from flowing on the ground.
• Loosen the filter cover in counter-clockwise and then empty water.
Note: You may have to empty the water collection vessel several times according to the
amount of water in the machine.
• Clean the foreign materials in the filter with a brush.
• After cleaning the filter, fit the cover and tighten it by rotating it in clockwise direction.
• While closing the pump cover, ensure that the parts on the inner side of the cover to
match the holes on the front panel side.
• You can reattach the pump cover in the reverse order that you removed it.
To Next Page
Loading...
Need help?
General
