www.heinner.com 7Kg, 220-240V~50Hz, 1400rpm
36
Unsatisfactory washing
result.
Your washing is too dirty for the
programme selected.
Use the information in the programme tables to select the
most appropriate programme.
Amount of detergent used
insufficient.
Use the amount of detergent as instructed on the
packaging.
There is too much laundry in your machine.
Check that the maximum capacity for the
selected programme has not been exceeded.
Unsatisfactory washing
result.
Increase the amount of detergent following the
manufacturer’s instructions.
Your laundry is too tightly packed together in
the drum.
Check that your laundry is spread out.
As soon as the machine
is loaded with water,
water discharges.
The end of water drain hose is too low for
the machine.
Check that the drain hose is at a suitable height.
(**) .
No water appears in
the drum during
washing.
No fault. Water is in the unseen
part of the drum.
. . . . . . . . . . . . . . . . . . . . .
Laundry has
detergent residue.
Non-dissolving particles of some detergents
may appear on your laundry as white spots.
Perform an extra rinse, or clean your laundry with a brush
after it dries.
Grey spots appear on
the laundry.
There is untreated oil, cream or ointment
on your laundry.
Use the amount of detergent as instructed on the packaging
in the next wash.
The spin cycle does not
take place or takes place
later than expected.
No fault. The Unbalanced load
control system has been activated.
The Unbalanced load control system will try to spread your
laundry. The spinning cycle will begin once your laundry is
spread. Load the drum evenly for the next wash.
(*) See the chapter regarding maintenance and cleaning of your machine.
(**) See the chapter regarding installation of your machine.
To Next Page
Loading...
Need help?
General
