HELI CPC 25 User Manual

1-2-3-4-11-10-8-9-12-16-15-14-13-19-20-5-21
Power flow in reverse 2nd speed gear position:
1-2-3-6-7-8-9-12-16-15-14-13-19-20-5-21
3.3 Reduction Gear (See Fig.3-12)
The reduction gear located in the front of the transmission is used to reduce the
speed and increase the torque from the output shaft of the transmission and impart
them to the differential. It consists primarily of a small spiral bevel gear on the output
shaft and a pinion shaft splined with a big spiral bevel gear. Both ends of the pinion
shaft are supported by tapered roller bearing. Several shims are installed between the
case and bearing covers to adjust the clearances between them.
Fig. 3-12 Reduction gear & differential
(1) Ring gear (2) Bolt (3) Bearing seat (4) Ball bearing (5) Thrust washer
(6) Tapered roller bearing (7) Bearing cover (8) Shim (9) O-ring (10) Output shaft
(11) Big spiral bevel gear (12) Pinion shaft (13) Knock pin (14) Planet gear shaft I
(15) Planet gear shaft II (16) Half shaft gear (17) Washer (18) Planet gear
-25-

HELI CPC 25 Specifications

General

Brand	HELI
Model	CPC 25
Category	Forklifts
Language	English